That must habe an other reason.I'm using dbuscontrol.sh integrated with LIRC to control the raspberry Pi B+ via an IR remote controller. I do not know if it's only because it is a "B" and not a B+ that solve this probel (but normally it should happen to the analog output and not on the HDMI output)? Hello, i have got some "scrash" sound when playing tv, i was thinking that it was related to the analog part, but even if i put the sound by hdmi i got this "crap" sound, it hapen some times, not always etc. Here is the command i have to put in //rc.suspend: In fact i think that we should unmount before. Hub-ctrl -h 0 -P 3 -p 1 => The key turn on. Hub-ctrl -h 0 -P 3 -p 0 => It turn off power of the key layer n Set the video render layer number (higher numbers are on top) key-config Uses key bindings specified in instead of the default fps n Set fps of video where timestamps are not present orientation n Set orientation of video (0, 90, 180 or 270) threshold n Amount of buffered data required to come out of buffering in seconds video_queue n Size of video input queue in MB audio_queue n Size of audio input queue in MB video_fifo n Size of video output fifo in MB audio_fifo n Size of audio output fifo in seconds win "x1 y1 x2 y2" Set position of video window lines n number of lines to accommodate in the subtitle buffer no-ghost-box no semitransparent boxes behind subtitles align left/center subtitle alignment (default: left) font-size size font size as thousandths of screen height italic-font path (default: /usr/share/fonts/truetype/freefont/FreeSansOblique.ttf) (default: /usr/share/fonts/truetype/freefont/FreeSans.ttf) subtitles path external subtitles in UTF-8 srt format no-osd do not display status information on screen amp n Set initial amplification in millibels (default 0) vol n Set initial volume in millibels (default 0) no-boost-on-downmix don't boost volume when downmixing Ignored if file is not seekable, start position applied if given r / -refresh adjust framerate/resolution to video z / -nohdmiclocksync do not adjust display refresh rate to match video y / -hdmiclocksync adjust display refresh rate to match video (default) 3 / -3d mode switch tv into 3d mode (e.g. o / -adev device audio out device : e.g. n / -aidx index audio stream index : e.g. In fact, the short jump is on the 1 and 3 key, you could test, you have got big jump in left and right, and short jump in 1 and 3.Īnd perhaps we should put the sound lower on launch. And there is no way to make shorter jumps, without compile the omxplayer myself. I will test the volume part by me self, to see how I must change the mplayer plugin to get the correct keys.īy the way: You must use the omxplayer.sh to check the key binding that is used by the plugin. You could invers the 1/3 key with left and right too because by default left and right are fast jump, not lot low jump.Īnd to play a video fast jump is to fast. You could test it again, perhaps i have made something wrong. Has i said, i have already change the key to + and - in the config file, and it has changed nothing. For the pi, just the command line à said is enouth to change the governor. Ok, i will try this package, even if it's not needed. Some questions on MLD on pi (From non German speaker!)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |